Pneumatic Die Lifters with Balls

Multi-directional Movement of Dies



This page currently is under reconfiguration and will be available for you within short time in full scope and in new design.

To change press dies without support by Die Lifters with Balls needs, depending on the weight of the press die, very strong forces. Thereby already the change of smaller press dies by the operator is a show of strengrh. To change bigger press dies without support by Die Lifters with Balls or Rolls is nearly impossible.


Die Lifters with Balls allow a multi-directional movement of the die and give the best possible manoeuvrability.

Beside of the well-known pneumatically operated Die Lifters with Balls with low friction and a load capacity of 1.000 kg / meter at a closeness of 40 balls per meter, for T-slot-sizes T-28 and T-36 we now also can offer to you a version with bigger load capacity at medium friction.

The pneumatically operated Die Lifters with Balls are designed for a working pressure of 6 bar compressed air and nearly reach a load capacity similar to the comparable Die Lifters with Rolls at a working pressure of 6 bar compressed air. At the same time they offer the advantage of the possibility of a multidirectional movement of the press die. 

Pneumatically operated Die Lifters with Balls offer these advantages:

• simple installation within existing T-slots without
  work-intensive and expensive hydraulic installation

• multig-directional movement of the dies is possible

• low friction, thereby protection of the bearing surface of the dies

• low purchase cost


Pneumatically operated Die Lifters with Balls are available for T-slots indicated below:

T-Slot-Dimension   Load Capacity           
                                    at 6 bar                   
----------------------------------------------- 
           T22                 1.000 kg / Meter  
           T28                 2.000 kg / Meter  
           T36                 2.500 kg / Meter  

Usual working pressure:  6 bar

 



The pneumatically operated Die Lifters with Balls, like the version with rolls shown here, for the lifting function are equipped with special hoses.
They can, like the Die Lifters with Rolls, also be fixed within corresponding T-Slot-Housings onto Die Change Tables or onto Die Change Carts. 
 
If you will have questions regarding our pneumatically operated Die Lifters with Balls or Rolls, we will be at your disposal for clarification at any time. Please do not hesitate to contact us:

Seidel Handlingsysteme GmbH
Phone:  0049 2156 419193
Mobile: 0049 171 2003018
Fax:     0049 2156 4979325
eMail:  info@seidel-handlingsysteme.de